Ge-monogram Range Manuel d'utilisateur télécharger pdf (Page 19)

TOOLS AND MATERIALS REQUIRED

• Gloves to protect against sharp edges

• T-15 and #2 Phillips screwdrivers

• Drill with 3/32" and 9/64" bits

•

Safety glasses

• Level

• Pencil

This Kit Includes

•

op w

all suppor

•

Bottom w

all support

• Top cover with shelf

• Bottom cover

•

Har

e package with

– 9 Stainless Steel Torx 15 #8

self-tapping scr

ews

– 9 Phillips #2 pan head w

ood #10 scr

ews

– 3 Stainless Steel #2 truss head

#10 screws (for alternate

installation method)

WARNING:

To prevent ignition of combustible materials,

the entire back wall above the range must

be protected by a backsplash constructed

of non-combustible material.

ACCESSORIES—30" TO 36" ADJUSTABLE BACKSPLASH (not included)

ZXADJB30PSS, ZXADJB36PSS, ZXADJB48PSS Accessory Installation

INSTALL THE WALL SUPPORT PANELS

ARNING:

The wall support panels

must be securely fastened to the wall. Failure to

do so could result in damage or personal injury.

IMPORTANT: This backsplash is designed to cover the wall

between the bottom of the hood and the top of the range.

The vent hood should be installed over the rangetop or

range before installing this backsplash.

• Install and level the Range/Rangetop according

to the product installation instructions.

• Remove backsplash packaging and protective film.

• Locate wall studs on each side. Where studs are not

available, plan to use wall anchors (not provided).

• Use a level to pencil 2 horizontal lines on the wall,

one 1/8" below the vent hood and the other 1/8" above

the Range/Rangetop. This 1/8" space allows the cover

panels to overlap the wall supports.

• Secure the top wall support panel to the wall with 4 wood

screws, through the outermost studs.

• Use 4 wood screws to secure the bottom wall support

panel. The center slot should be positioned at the top.

The gap between the top and bottom support panels

will be covered by the top cover with shelf.

1/8″

Secure the top

panel to the wall

with 4 wood

screws

1/8″

Secure

the bottom panel

to the wall with

4 wood screws

Center

Arrow

Wood Screws

Wood

Screws

Top Wall

Support

Top Cover

with Shelf

Bottom Cover

Bottom Wall Support

761Dia65

Hardware

Package

BEFORE YOU BEGIN

Read these instructions completely

and carefully.

IMPORTANT: Save these instructions for local

inspector’s use.

IMPORTANT: OBSERVE ALL GOVERNING CODES

AND ORDINANCES

TE TO INSTALLER

: Be sure to leave these

instructions with the Consumer.

NOTE T

O CONSUMER: Keep these instructions

with your Owner’s Manual for future reference.

• This backsplash adjusts to fit the space between

the t

op of the range and the bottom of the hood,

from 30" Min. to 36" Max. height.

• Maximum shelf load-bearing weight is 40 lbs.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Ge-monogram Range Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Radio Ge-monogram Range